The benefits of using gas generator set?
一、Rational utilization of energy, reduce environmental pollution
However, the alligators are not enough to improve the quality of the difficult-to - use halos. Using natural gas for power generation not only protects the environment, but also, more importantly, saves energy.
二、Mature technology, reliable equipment
The use of natural gas for power generation, in Europe, France and Britain and other countries have 50 or 60 years of history, the largest single capacity has reached 7000kW. In China, there have been nearly 20 years of successful operation experience, domestic gas generator set put on the market for more than 10 years. For small gas-fired power stations with single unit capacity below iOOOkW, domestic generator sets can completely replace imported ones, and domestic units are more advantageous in terms of overhaul, maintenance and after-sales service.
The electronic ignition system of gas generator is composed of ignition signal generator, ignition amplifier module, ignition coil, high voltage damping line and spark plug. According to each cylinder engine needed, the signal generator to generate and crankshaft position corresponding to the voltage pulse signal, the ignition according to the voltage pulse signal amplification module on secret off the ignition coil primary circuit in time, make the secondary ignition coil produces high pressure, the high damping line, the spark plug in the combustion chamber to produce sparks, ignite mixture.
三、Inspection installation gas generator：
When the signal generator is installed, the clearance between the bottom of the signal generation sensor and the tachometer plate is 0.5mm 0.12mm. During installation, the sensor can be firstly rotated to the end face of the tachometer plate, and then exit for about 1/2 turn, and then the nut can be tightly locked.
The output lines A, B, C and D of the ignition unit (four-cylinder machine) are connected to the positive pole of the ignition coil of cylinder 1, 3, 4 and 2 respectively, and the output line E is connected to the negative pole of each ignition ring. The difference is that the negative pole of the coil of cylinder 1 and 4 is connected to the body. Ignition single element (6 cylinder machine) output line A, B, C, D, E, F are connected to 1, 5, 3, 6, 2, 4 cylinder ignition coil positive pole, output line J is connected to each ignition coil negative pole, and in 1, 6 cylinder coil negative pole is connected to the body.